[Next] [Previous] [Up] [Top] [Contents] [Back]

2.5 SCSI Bus Connection Options

2.5.1 SCSI-3 Option

This option uses the BI0319 to connect to the SCSI bus signals on the VMEbus P2.

Figure 2-2 SCSI-3 Daisy-Chain Option

This setup connects the BI0316 to a 16-bit (WIDE) Single-Ended or Differential SCSI bus. Note that if either the cable at the front or at the rear connector is not inserted, termination must be applied to this connector. The following table contains a list of products to achieve this termination.

Termination Products for 68-pin High Density Connector
ProductDescriptionManufacturer
0-0869516-1Amplimite .050 Series SCSI-3 Terminator Low Profile with Jack Screws, Single-Ended 68 positionsAMP
0-0869515-1Amplimite .050 Series SCSI-3 Terminator Low Profile with Jack Screws, Differential 68 positionsAMP

When the cable at the front has to connect to an 8-bit device, special care has to be given to the Upper Byte termination. See "Mixing Buses Having Different Widths".

BI-0316 - Mass Storage Module - 6 DEC 1996 Copyright © 1996 Brand Innovators B.V. [Next] [Previous] [Up] [Top] [Contents] [Back]